科特固石寶防水背膠,是一種由水生高分子聚合物和多種無機硅酸鹽凝膠材料配制而成的雙組份產品,具有很好的防水性能、干燥收縮小、有韌性與水泥基材料粘結力強等特點,避免了石材濕貼施工后易起殼、脫落和表面產生白華的缺陷。
一、用途:
1、用于粘貼大理石的增強背網,背網層不需鏟除,提高粘結強度和防水性能。
2、用于濕貼施工的石材、大規格墻地磚,提高粘貼面粘結強度和防水性能。
二、特點:
1、石材背面防護材料,硬化收縮小且有韌性;不污染環境對人體無害,環保。
2、持久粘貼,不脫層起殼。
3、與水泥砂漿粘接良好,施工時無需鏟,減少破損。
4、防水抗滲,有效防止水斑,白華。
三、使用說明:
1、材料拌制:將液體與粉來體以1:3的重量比放入攪拌桶內,用電動攪拌機攪拌均勻,制成糊狀混合物,靜置5-10min后涂刷。拌好的漿料控制在2h內用完。
2、粘貼背網:將適量的漿料倒于石板底部粘結面,用批板將漿料均勻批涂于整個粘結面,厚度約0.3-0.5mm;將預先裁切好的網格布壓平并再次薄涂一層漿料,厚度約0.3-0.5mm;自然晾干,也可烘干至表干,過1-2天背網層實干后可進行打磨、切割。
四、包裝運輸:
1、本產品為非易燃品,非危險品,能運輸,避免雨淋和撞跌,破壞包裝。
2、本產品應貯存在干燥陰涼的倉庫內,忌長期暴露在空氣中。
3、本產品保存期為6個月。
4、液體組份用塑料桶包裝:小桶:20kg/桶、大桶:200kg/桶;粉體組份用復合紙袋包裝:20kg/袋。
五、注意事項:
1、嚴格按規定的配比,攪拌均勻;
2、施工時不得添加其它材料和外加劑;
3、每次施工完畢,用清水清洗工具及機械設備。
Cote solid Shibao waterproof adhesive, a polymer composed of water and a variety of raw inorganic silicate gel material prepared from the two-component products, with very good water resistance, drying shrinkage, toughness strong bond with the cement-based materials, etc., to avoid the easy to play after the construction shell stone wet paste, Bai Hua loss and surface defects.
First, use:
1. for pasting marble enhanced back net, back mesh layer without eradication, improve bond strength and water resistance.
2. for the construction of the stone wet paste, large size tiles, improve bond strength and waterproof adhesive surface properties.
Second, characteristics:
1. the back of the stone protective materials, curing shrinkage and toughness; do not pollute the environment on humans, safety and environmental protection.
2. lasting paste, no delamination from the shell.
3. with good adhesion to cement mortar, the construction without shovel, reducing breakage.
4. water impermeability, prevent water spots, Bai Hua.
Third, instructions:
1. Material mixing: The liquid and powder to form a 1: 3 ratio of weight into the mixing bucket, stirring with an electric mixer evenly to form a paste mixture, after standing 5-10min brushing. Marinated stock control used within 2h.
2. paste the back net: An appropriate amount of slurry is poured in stone at the bottom of the adhesive surface, the slurry was uniformly with approved board approved the adhesive applied to the entire surface, a thickness of about 0.3 -0 5mm;. The precut good mesh flatten and thin again coat of paste, a thickness of about 0.3-0.5mm; dry naturally, can also be dried to form dry, too l-2 天 back net after layer of hard work can be polished, cut.
Fourth, packaging and transportation:
1. the product is non-flammable, non-hazardous, safe transport, to avoid the rain and hit down, destroying the packaging.
2. The product should be stored in a cool dry warehouse, avoid long-term exposure to air.
3. the product shelf life of six months.
4. the liquid component with a plastic pail: kegs: 20kg / barrel vat: 200kg / barrel; powder components with composite bag: 20kg / bag.
V. Note:
1. in strict accordance with the provisions of proportion, stir;
2. can not add other materials and additives construction;
3. each construction is completed, with water cleaning tools and equipment.




